[product name] self adhesive wound protector

[specification and model] model: type I, type II, type III, type IV; specification: length (1cm-200cm) × width (1cm-200cm) tolerance ± 10%. For specific specifications, please refer to product small package.

[name of registrant] Henan Jianqi medical device Co., Ltd

[residence] dingluan Industrial Zone, Changyuan County

[Tel.] 0373-8690789

[after sales service unit] Henan Jianqi medical equipment sales Co., Ltd

[name of manufacturer] Henan Jianqi Medical Equipment Co., Ltd

[residence] dingluan Industrial Zone, Changyuan County

[production address] dingluan Industrial Zone, Changyuan County

[contact information] 0373-8690789

[production license] ysyjx production license No. 20080036

[Registration Certificate No.] yxzz 20172640058

Self adhesive wound dressing

[structure and composition] type I: made of spunlaced nonwovens, absorption core pad and isolation paper; type II: made of spunlaced nonwovens and isolation paper; type III: made of transparent film tape, absorption core pad and isolation paper; type IV: made of transparent film tape and isolation paper.

[scope of application] it is used for operation, trauma wound, application of indwelling arteriovenous catheter and wound of infant umbilical cord.

[precautions] 1. This product is disposable and its package is damaged. It is forbidden to use it and destroy it after use.

2. See the seal or label of the package for the batch number and the outer packing box for the sterilization date.

3. The product was sterilized by ethylene oxide.

[usage] 1. Select the applicable specification and model, and open the package after confirming that the outer package is in good condition.

2. Gently remove the isolation paper, align the absorption core pad with the wound for the product with absorption core pad, and then gently stick the adhesive tape to the patient's skin.

3. After the end of use, the product should be treated as medical waste to avoid pollution.

[storage method] 1. The product should be loaded and transported in covered carriage and cabin, and kept clean. It should not be under heavy pressure, direct sunlight, rain or snow.

2. Handle with care to avoid violent collision;

3. The product should be stored away from the fire source, the relative humidity is not more than 80%, no corrosive gas and well ventilated and clean environment.